Preventative Water Heater Maintenance in 10 Minutes

Posted by on Sep 24, 2014 in Water Heater Repair Alpharetta GA

Water heater maintenance in ten minutes? Yep, that’s right. Water Heater Repair Alpharetta GA is going to show one how to perform some water heater preventative maintenance. And, that is the amount of time it will take to complete these 2 important water heater maintenance tasks; nevertheless, we understand that these will do an exceptional task of helping with three things:

  • Having ones water heater last as long as possible for it will save on cash with using it.
  • Seeing to it ones water heater runs safely is critical for we do not desire it to blow up in in ones house.
  • And having it run more energy efficiently also helps one conserve one some money.

We are now prepared to invest ten minutes once or two times a year to assist in saving some cash on energy costs.

Testing the T&P Relief Valve
The T&P Valve, or the temperature and pressure relief valve, has a crucial task. It’s job is to assist to make sure excess pressure inside the water tank does not build up, or in much more basic terms, it makes certain that a water heater does not blow up. The T&P valve has a lever or little handle. All one has to do is raise it some then let go of it back. It should snap back to its shut position quickly. A little water should be heard entering into the drain pipe below the lever that was just lifted and maybe heard some pressure being released at the same time. If none of these things have happened during the test, the valve will need to be changed.

Carry out a Mini Water Heater Tank Flush
Unfortunately, rust and corrosion will take place inside the water tank because of the chemical reactions taking place with all the elements inside that are required to heat up water. We will not get overly technical right here, however it is simple to help prevent this process by doing a flush or draining of all or a portion of the water in the storage tank.

For just a tiny flush, position a bucket under the drain valve below the tank. Open the drain valve and fill the bucket with water. Drain a minimum of a few gallons of water in total. Let the water sit in the pail for a few minutes to settle and analyze if there is much that settles to the bottom of the pail. If there is, if the water heater has actually not been drained for a long period of time (or ever), it would be best to do a complete flush of the tank to get as much of the sediment out as possible. You will wish to turn the temperature level dial down and might want to let the water cool down for about an hour first so it is not too hot while draining it. Also, it would be simpler to attach a hose to the drain valve and let the water go outside instead of making use of pails.

If the water looks reasonably clean and clear from the mini test you should be all set. When the water heater has an excessive quantity of sediment inside of it, it can make loud popping noises and it minimizes its effectiveness too.

Though water heaters are fairly upkeep free and not challenging to operate, whenever one feels the slightest uncomfortable or are uncertain of exactly what to do, it is always best to have give Water Heater Repair Alpharetta a call to assist with ones regular water heater maintenance.

Here is an infographic that illustrates these steps, and check out our blog more water heater tips and advice.

Water Heater Repair Alpharetta GA